Advertisement
4000 Series
DRAIN
(E) KE25 Series
(C) KE21-7000 Series
INSTALLATION INSTRUCTIONS
WALL
BRACKET
MIXING VALVE INSTALLATION
IMPORTANT:
When adjusting temperature, turn dial toward 'C' until it stops.
Then slowly begin turning toward 'H' until desired temperature is reached.
NOTE: Dial will continue to turn past highest number.
800-526-3694 • www.encoreplumbing.com
KE16 SERIES INSTALLATION
1.
AVOID CONTACT WITH WATER DURING ASSEMBLY TO M
CHANCE OF WATER DAMAGE.
2.
PUNCH HOLE AS PER SUPPLIED TEMPLATE.
3.
PASS SENSOR CABLE THROUGH MOUNTING HOLE AND
FAUCET ON THE SINK WITH PROVIDED MOUNTING HARD
4.
CONNECT 90 DEGREE ELBOW AT THE FAUCET SHANK.
5.
CONNECT CONNECTOR HOSE TO THE ELBOW.
KE25 / KE28 SERIES INSTALLATION
6.
MOUNT BELOW DECK CONTROL BOX AT APPROPRIATE D
BELOW SINK (SO SENSOR CABLE CAN CONNECT) USING
1. AVOID CONTACT WITH WATER DURING ASSEMBLY TO
TWO MOUNTING SCREWS (NOT PROVIDED) IN OPPOSITE
MINIMIZE CHANCE OF WATER DAMAGE.
7.
CONNECT OTHER END OF CONNECTOR HOSE TO THE SO
2. INSTALL DRAIN ONTO SINK.
8.
CONNECT SUPPLY HOSES TO THE MIXING VALVE.
3. MOUNT BRACKET (WALL BRACKET) ONTO WALL.
9.
REMOVE BLACK CAP FROM CONTROL BOX CABLE AND C
CONNECT CONNECTOR HOSE TO THE 90 DEGREE ELBOW
CABLE TO THE SENSOR.
BEHIND SINK.
10.
CONENCT POWER SUPPLY (IF PROVIDED) TO THE WALL
11.
FAUCET SHOULD START WITHIN COUPLE OF SECONDS.
4. MOUNT SINK ONTO THE WALL BRACKET.
5. MOUNT BELOW DECK CONTROL BOX AT APPROPRIATE
DISTANCE BELOW SINK (SO SENSOR CABLE CAN CONNECT)
USING MINIMUM TWO MOUNTING SCREWS (NOT
KE25 / KE28 SERIES INSTALLATION
PROVIDED) IN OPPOSITE CORNERS.
6. CONNECT OTHER END OF CONNECTOR HOSE TO THE
SOLENOID.
1.
AVOID CONTACT WITH WATER DURING ASSEMBLY
TO MINIMIZE INSTALL DRAIN ONTO SINK.
7. CONNECT SUPPLY HOSES TO THE MIXING VALVE.
2.
CHANCE OF WATER DAMAGE.
8. REMOVE BLACK CAP FROM CONTROL BOX CABLE AND
3.
MOUNT BRACKET (MOUNTING BRACKET) ONTO
CONNECT CABLE TO THE SENSOR.
WALL. CONNECT CONNECTOR HOSE TO THE
9. CONNECT POWER SUPPLY (IF PROVIDED) TO THE WALL
90 DEGREE ELBOW BEHIND SINK.
OUTLET.
4.
MOUNT SINK ONTO THE WALL BRACKET.
10. FAUCET WILL START WITHIN A COUPLE OF SECONDS.
5.
MOUNT BELOW DECK CONTROL BOX AT APPROPRIATE
DISTANCE BELOW SINK (SO SENSOR CABLE CAN CONNE
USING MINIMUM TWO MOUNTING SCREWS
(NOT PROVIDED) IN OPPOSITE CORNERS.
6.
CONNECT OTHER END OF CONNECTOR HOSE TO
THE SOLENOID.
7.
CONNECT SUPPLY HOSES TO THE MIXING VALVE.
8.
REMOVE BLACK CAP FROM CONTROL BOX CABLE
AND CONNECT CABLE TO THE SENSOR.
9.
CONNECT POWER SUPPLY (IF PROVIDED) TO THE
WALL OUTLET.
10.
FAUCET WILL START WITHIN A COUPLE OF SECONDS.
Advertisement
