Power Supply - Philips AZ2010/05 User Manual

Batteries
Whenever convenient, use the power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall socket before inserting batteries.
Batteries (optional)
1. Open the battery compartment and insert six batteries, type
R20, UM1 or D-cells (preferably alkaline) with the correct
polarity as indicated by the "
compartment.
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
– Do not mix battery types, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
– When inserting new batteries, do not try to mix old
batteries with the new ones.
– Remove the batteries if the set is not to be used for a long
time.
Batteries contain chemical substances, so they should
be disposed of properly.
For users in the U.K.: please follow the instructions on page 2.
USING THE AC MAINS
1. Check if the power voltage as shown on the type plate on
the base of the set, corresponds to your local power
voltage. If it does not, consult your dealer or service
organisation.
2. If your set is equipped with a voltage selector, adjust it so
that it matches with the local power.
3. Connect the mains lead to the MAINS V socket and the wall
socket.
– The mains supply is now connected and ready for use.
4. To switch off completely, withdraw the mains lead from the
wall socket.
• Disconnect the mains lead from the wall socket to protect
your set during heavy thunderstorms.
+ -
" and " " symbols inside the
AZ 2010 /00
page

POWER SUPPLY

5
MAINS
5