1. Manuals
  2. Brands
  3. Philips Manuals
  4. CD Player
  5. AZ2010/10
  6. User manual

Philips AZ2010/10 User Manual

Cd radio cassette recorder
Hide thumbs

Advertisement

Table of Contents

AZ 2010
CD Radio Cassette Recorder

Advertisement

Table of Contents
loading

Related Manuals for Philips AZ2010/10

Summary of Contents for Philips AZ2010/10

  • Page 1 AZ 2010 CD Radio Cassette Recorder...
  • Page 2 Radio cassette grabadora con CD AZ 2010/01 110–127/220–240 V; ~50–60 Hz 22 W Philips Mexicana, S.A. de C.V. Norte 45, # 669, Col. Industrial Vallejo C.P. 02300 México D.F., Tel. 728 42 00 Philips HK, Ltd. China...
  • Page 3 23 4 5 6 8 9 0 ! @ # $ % ^ & • 127V • 240V...

  • Page 4: Top And Front Panel

    CONTROLS TOP AND FRONT PANEL 1 p 3.5 mm stereo headphone socket Note: – Connecting headphones will switch off the speakers 2 VOLUME - to adjust volume level 3 Bass control - to select a more vivid bass response: OFF, DYNAMIC BASS BOOST, ULTRA BASS 4 INCREDIBLE SURROUND - to create a phenomenal stereo effect...

  • Page 5: Power Supply

    Batteries Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall socket before inserting batteries. Batteries (optional) 1. Open the battery compartment and insert six batteries, type R20, UM1 or D-cells (preferably alkaline) with the correct +”...

  • Page 6: Digital Tuner

    OPERATION GENERAL OPERATION 1. Adjust the source selector to your desired sound source: OFF/ TAPE, TUNER, CD. 2. Adjust the sound using the VOLUME, INCREDIBLE SURROUND and , DYNAMIC BASS BOOST, ULTRA BASS controls. 3. To switch off the set, adjust the source selector to OFF/TAPE position and check that the cassette keys are released.

  • Page 7: Programming Radio Stations

    DIGITAL TUNER PROGRAMMING RADIO STATIONS 1. Tune to your desired station, following steps 1-4 under ‘RADIO RECEPTION’. ™ If the frequency is already stored in the memory, the preset number will be displayed. 2. Press PROG to activate programming. ™ flashes in the display.

  • Page 8: Selecting A Different Track

    CD PLAYER PLAYING A CD 1. Set the source selector to CD. 2. To open the CD door, press OPEN on the CD door. 3. Insert a CD with the printed side facing up and press the CD door gently to close. 4.

  • Page 9: Programming Track Numbers

    CD MODE: SHUFFLE & REPEAT The CD MODE button allows you to select 4 different play modes. The modes can be selected or changed during playback. SHUFFLE - All tracks are played in random order. SHUFFLE REPEAT ALL - Repeats the entire CD or programme in random order.

  • Page 10: Cassette Recorder

    CASSETTE RECORDER PLAYING A CASSETTE 1. Set the source selector to TAPE. 2. Press STOP•OPEN 9 / to open the cassette holder and insert a cassette. 3. Close the cassette holder. 4. Press PLAY 1 to start playback. 5. Adjust the sound using the VOLUME, INCREDIBLE SURROUND and BASS controls 6.

  • Page 11: Synchro Start Cd Recording

    SYNCHRO START CD RECORDING 1. Set the source selector to CD. 2. Insert a CD and if desired, programme track numbers. 3. Press STOP•OPEN 9 / to open the cassette holder. Insert a blank tape. 4. Close the cassette holder. 5.

  • Page 12: Precautions & General Maintenance

    MAINTENANCE PRECAUTIONS & GENERAL MAINTENANCE • Place the set on a hard and flat surface so that the system does not tilt. • Do not expose the set, CDs, batteries or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.

  • Page 13: Troubleshooting

    If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee PROBLEM –...

This manual is also suitable for:

Az2010/11Az2010Az 2010Az 2010/01

Table of Contents