Cree Edge Series Installation Instructions

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. When handling, hold luminaire on sides to prevent damage to the top screen or LED's.
3. This luminaire must be installed in accordance with the NEC or your local electrical
code. If you are not familiar with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local.
Si vous n'êtes pas familier avec ces codes et ces exigences, veuillez contacter un
électricien qualifié.
SAVE THESE INSTRUCTIONS FOR FUTURE
TO INSTALL:
1
(4) Luminaire Mount Screws
2
(4) 1/2" threaded holes
(4) Mounting
Holes
3 Conduit Knockouts
Locations
(2) Installation
Support Cables
1 of 2
INSTRUCTIONS
REFERENCE
Mounting Box
(4) Mounting Holes
(2) Keyhole
Conduit
Knockouts
Knockout
Luminaire Mount
Screws
Wiring Knockout
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
WALL MOUNTING
STEP 1:
IMPORTANT – If needed, the (2) Keyhole knockouts located
inside box may be removed, but are for alignment only. See
Figure 2. Luminaire is to be supported by (4) 3/16" mounting
holes. The Mounting holes will accommodate a #10 bolt.
Select appropriate customer supplied mounting hardware for
mounting surface. See Figure 2 and 5.
STEP 2:
Place mounting box over junction box or conduit. If mounting
over junction box a 2-1/2" Inspection knockout hole is
included. See Figure 2 and 5.
NOTE: See Figure 4 for minimum mounting box distance to
achieve a required 3" clearance.
STEP 3:
For surface wiring (4) 1/2" threaded holes are available. See
Figure 2 and 5.
STEP 4:
If mounting on a uneven surface, place a minimum of a 1/4"
bead of high grade silicone on the black gasket encompassing
the Inspection Knockout hole on the back of the mounting box.
See Figure 5.
STEP 5:
If mounting over surface mounted conduit use the knockout
conduit openings located on the top, bottom, or sides of the
luminaire. Knockouts can be removed by using a hammer or
pliers. See Figure 3.
STEP 6:
Before securing to wall mounting surface, make sure
mounting box is level.
STEP 7:
Secure mounting box to wall.
STEP 8:
For ease of installation, hook the (2) installation support cable
loops on the top screws of the mounting box.
STEP 9:
Make wiring connections per the Electrical Connections
section on the next two pages.
THE EDGE
®
LED Security Wall Mount
Includes: SEC-EDG-WM
CI321X01R0_B