Table of Contents
Advertisement
Quick Links
Mounting Instruction
Directional diversity antenna linear for 2.4 GHz, 5 GHz
5 GHz MiMo antenna for sectoral illumination
BAT-ANT-N-8G-DS-IP65
BAT-ANT-N-9A-DS-IP65
BAT-ANT-N-MiMo5-9N-IP65
Safety instructions
ELECTRIC SHOCK OR FALLING
Avoid mounting the antenna near power lines.
When installing an antenna from a ladder or elevating equipment, take
precautions to avoid falling and ensure the equipment is securely positioned
on solid ground.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
General instructions
If exposed to extreme environmental conditions, especially icy conditions
or a polluted atmosphere, the connectors should be covered with a self-
vulcanizing tape or a cold shrink tube.
Mounting Instruction
Release 02 06/10
WARNING
Technical Support
HAC.Support@Belden.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Belden HIRSCHMANN BAT-ANT-N-8G-DS-IP65
Summary of Contents for Belden HIRSCHMANN BAT-ANT-N-8G-DS-IP65
-
Page 1: Safety Instructions
General instructions If exposed to extreme environmental conditions, especially icy conditions or a polluted atmosphere, the connectors should be covered with a self- vulcanizing tape or a cold shrink tube. Mounting Instruction Technical Support Release 02 06/10 HAC.Support@Belden.com... - Page 2 Disclaimer All pertinent country, state, regional, and local safety regulations must be observed when installing and using this product. For reasons of safety and to help ensure compliance with documented system data, only the manufacturer should perform repairs to components. This equipment must only be installed and serviced by qualified personnel.
- Page 3 Mounting the antenna on the holder Set the antenna on the guide and slide it down until it engages. Figure 3: Mounting the antenna on the holder To remove the antenna, slide it up until the catch releases. Mounting the connecting cable ...
- Page 4 Mounting the holder on a bracket Choose the bracket mounting position, as shown. Mount the holder on the bracket using the M4 screws, as shown. Note: Use a tightening torque of 13.2 lb in / 1.5 Nm. Note: The holder and screws you will find in a separate parts kit.
- Page 5 Surface mounting the bracket Mount the bracket on the flat surface, as shown. Note: Depending on the flat surface material, you can omit the plugs. Note: The plugs and screws you will find in a separate parts kit. Figure 7: Mounting the bracket on a flat surface, with plugs (Ø...
-
Page 6: Aligning The Antenna
Aligning the antenna Note: Do not attempt to change the position of the antenna after the mounting screws have been tightened. Align the antenna in the desired position. Tighten the vertical axis (1) using a M5 srew. ... - Page 7 Mounting the connecting cable Attach the connecting cable to the antenna cable connection. Tighten the coupling nut. Note: Use a maximum coupling nut torque of 17.7 lb in / 2 Nm. Figure 10: Connecting the cable Mounting Instruction Release 02 06/10...
- Page 8 Mounting Instruction Release 02 06/10...
Need help?
Do you have a question about the HIRSCHMANN BAT-ANT-N-8G-DS-IP65 and is the answer not in the manual?
Questions and answers