Advertisement
Quick Links
DEC 4000 Model 6x0/7x0 AXP Series
TLZ07 Tape Drive Installation
EK–TLZ07–IN. A01
July 1994
This document illustrates how to install the TLZ07 tape drive in a DEC 4000
Model 6x0 or Model 7x0 AXP series system.
© Digital Equipment Corporation 1994. All rights reserved.
S2520
1
Advertisement
Related Manuals for Digital Equipment TLZ07
Summary of Contents for Digital Equipment TLZ07
- Page 1 DEC 4000 Model 6x0/7x0 AXP Series TLZ07 Tape Drive Installation EK–TLZ07–IN. A01 July 1994 This document illustrates how to install the TLZ07 tape drive in a DEC 4000 Model 6x0 or Model 7x0 AXP series system. © Digital Equipment Corporation 1994. All rights reserved. S2520...
- Page 3 Tabletop drive TLZ07–DA Field Replacable Parts and Options TLZ07 tape drive TLZ07–BA Cassette tape TLZ04–CA (60 m = 2.6 GB) TLZ06–CA (90 m = 4.0 GB) TLZ07–CA (120 m = 8.0 GB) Head cleaning cassette TLZ04–HA Compressed mode data capacity...
- Page 4 DEC OSF/1 AXP Factory Installed Software User Guide Figure 1 shows the indicators, jumpers, and connectors on the TLZ07 tape drive. Table 1 shows the default switch settings, and Table 2 describes the light indications. Table 1 SCSI ID / Option Selection Switch...
- Page 5 TLZ07 When the media recognition system is enabled on the TLZ07 cassette tape drive (S4 off), the TLZ07 drive reads the header information on the cassette tapes to determine if the tape meets the MRS standard. Although it can read any 4 mm cassette tape, the drive will only write to tapes that meet the MRS standard.
- Page 6 TLZ07 Figure 1 TLZ07 Cassette Tape Drive Connectors and Indicators Tape Tape Write-Protect Tape Activity Cassette Unload Light Light Button Slot Power Term SCSI SCSI Remote Connector Power Connector Pin 1 Pin 1 ID Pins TLZ07 SCSI ID Switch Selection...
-
Page 7: Installation
Figure 6 shows the location of the bus continuity cards. To install a TLZ07-MX tape drive in your system, perform the following steps: 1. Slide the TLZ07-MX mounting bracket assembly into the option storage slot and push until the connector on the SCSI paddle card on the drive mounting bracket engages securely into the backplane. - Page 8 TLZ07 • Remove any SCSI ID cables from the OCP connector on the bezel assembly. • Loosen the two captive screws that secure the mounting bracket to the chassis. • Pull on the mounting assembly until it slides away from the chassis.
- Page 9 TLZ07 11. Attach each SCSI ID cable into the appropriate connector on the OCP connector board on the bezel (Figure 2). The top connector corresponds with the left storage slot, and the bottom connector corresponds with the right storage slot. The bezel is marked to show the corresponding SCSI ID plug for each slot.
- Page 10 TLZ07 Figure 2 Installing a TLZ07-MX Tape Drive Tighten screw. Tighten screw. Insert SCSI ID connector. Insert bezel. MLO-012702 Note When a removable-media compartment is empty, blank bezels are required to maintain maximum air flow.
- Page 11 TLZ07 Figure 3 Inserting Mounting Screws Mounting Screws Grounding Strip MLO-012703...
- Page 12 TLZ07 Figure 4 Removal of Blank Panel Push Spring Tab Remove Blank Panel Blank Panel MLO-010646...
- Page 13 TLZ07 Figure 5 Removal of Blank Flat Plugs Front Rear Push Back Two Spring Tabs Blank Flat Plugs Lift Out Remove Blank Board Flat Plugs Note: Re-install board and then insert standard ID plugs. MLO-010648...
- Page 14 TLZ07 Figure 6 Bus Continuity Card Dual Half-Height SCSI Drives Full-Height SCSI Drives Continuity Card Full-Height SCSI Drives Dual Half-Height SCSI Drives Full-Height Full-Height SCSI Drives SCSI Drives MLO-009431 Note When either the J6 or J7 backplane connector is not used, insert a bus continuity card into those slots to maintain bus continuity.
- Page 15 TLZ07 Table 2 TLZ07 Light Summary Write-Protect Light Tape/Activity Light (Amber) (Green) Condition No tape loaded. Tape loaded and write- enabled, no SCSI activity. Blinks Tape loaded and write- enabled, SCSI activity. Tape loaded and write- protected, no SCSI drive activity.
- Page 16 TLZ07 Figure 7 Inserting and Removing a TLZ07 Cassette Write- Write- Protected Enabled Insert cassette. Push eject button. Remove cassette. MLO-008662...