Download  Print this page

Whirlpool AGB 511/WP Installation, Operating And Maintenance Instructions

50 lt
Hide thumbs

Advertisement

0037_GB_42
92204355
06/2009
Validity from serial number
Installation, operating and
maintenance instructions
ELECTRIC KETTLES 50 lt
AGB 511/WP

Advertisement

Table of Contents
loading

  Related Manuals for Whirlpool AGB 511/WP

  Summary of Contents for Whirlpool AGB 511/WP

  • Page 1 0037_GB_42 92204355 06/2009 Validity from serial number Installation, operating and maintenance instructions ELECTRIC KETTLES 50 lt AGB 511/WP...
  • Page 2: Table Of Contents

    INDEX Models and dimensions Commissioning and testing page page Maintenance of the appliance General reminders and notes Possible failures and their elimination Technical data Use and cleaning Construction Warnings and hints for user Laws, technical prescriptions and Instructions for use directives Filling the jacket Special requirements for the installation...
  • Page 3: Models And Dimensions

    Models and dimensions AGB 511/WP Hot water connection to 10 mm Electrical connection Cold water connection to 10 mm Selector Operation light Pressure gauge Cooking vat drainage tap Vat water feed tap Level water jacket Orange warning light Operating thermostat...
  • Page 4: Operating Thermostat

    Controls Selector switch 50% power 100% power 100% power Operating thermostat Position OFF Position MAX 037 - 03 - Electric kettles 50 lt...
  • Page 5: General Reminders And Notes

    AND INSTALLED IN A WELL-VENTILATED ROOM. READ THE INSTRUCTION MANUALS BEFORE INSTALLING AND USING THE APPLIANCE. THE APPLIANCE MUST BE INSTALLED BY QUALIFIED PERSONNEL. 3 - TECHNICAL DATA Model AGB 511/WP Width (A) Depth (B) Height (C) Vat diameter Vat height...
  • Page 6: Construction

    Construction comply with the following regulations: - current regulations on the matter; - Main structure in AISI 430 with 4 adjustable height feet. - any hygienic-sanitary regulations concerning cooking - Panels in stainless steel AISI 304, thickness 10-12/10. environments; - Cooking vat in stainless steel AISI 316, thickness 20/10. - municipal and/or territorial building regulations and fire - Chrome-plated brass drainage tap.
  • Page 7: Connection To Waterworks

    Connect the terminal on the lower right-hand side marked cording to standards. with the international symbol a connector with a nominal In addition, check that once the appliance has been in- cross section <10 mm . All the appliances installed and the stalled, the power cord is neither subject to stretch nor in earth system of the building shall be connected like this.
  • Page 8: Use And Cleaning

    USE AND CLEANING Warnings and hints for user Energising the unit: This manual contains all the instructions required for a proper Connect the appliance by turning on the main switch in- and safe use of our appliances. stalled before it. Keep the manual in a safe place for future consultation! Start of cooking: This appliance is for catering use, hence they must be used...
  • Page 9: How To Proceed, If

    THE 2002/96/EC DIRECTIVE (WEEE): The manufacturer shall not be held responsible nor information to users has any warranty commitments for damage caused This informational note is meant only for owners by non-compliance with prescriptions or by installa- of equipment marked with the symbol shown in tion not in conformity with instructions.
  • Page 10: Wiring Diagrams

    Wiring diagrams L1 L2 L3 400V 3N P1 P2 P3 P4 L1 L2 L3 mA Line input terminal board 230V 3 TS Safety thermostat C1 Electromagnetic switch L1 Pilot lamp green (voltage) L2 Pilot lamp yellow TL Thermostat R1 Heating element SE Four position selector/switch Rm Relay for min.
  • Page 11: Warning

    TO MAKE ANY CHANGES DEEMED NECESSARY. THE MANUFACTURER CANNOT BE HELD RESPONSI- BLE IF THE INSTRUCTIONS CONTAINED IN THIS MA- NUAL ARE NOT OBSERVED. WHIRLPOOL EUROPE srl V.le Guido Borghi, 27 I – 21025 Comerio – VA 037 - 03 - Electric kettles 50 lt...