Installation Instruction; Electric Connection - Atosa MWF9007 Instruction Manual

Installation Instruction

--Unpacking and Handling
The freezer is in the package of cardboard box with foam boards protect when it arrives at user's place.
The freezer must be transported and handled with care to avoid posing a hazard to persons or property.
Never place a freezer on its side or turn it upside down as this may damage or impair operation of the
refrigerated unit.
We can not held liable for any damage or defects arising directly or indirectly from improper handling
of the equipment or non-compliance with the safeguards illustrated above.
-- Side clearance for the freezer
Install the freezer in an indoor and well-ventilated area with even flat ground.
Keep side clearance for the freezer, leave a 3 inch
(75mm) clearance at each side of the freezer for
adequate air circulation.

--Electric connection

WARING
Electric connection must be carried out by professional and qualified persons
The mains voltage corresponds to the voltage on the freezer 115V/60Hz/1Ph;
to ensure proper
operation it is essential for the power supply voltage to come within a range of +/-10% of the unit's
rated voltage.
The freezer should be plugged into a grounded and properly-sized electrical outlet with appropriate
overcurrent protection. Please refer to the electrical requirements on the nameplate.
Make sure that your unit has its own dedicated outlet. Do not use an extension cord.
Do not cut, remove or bypass the grounding prong
Email: Service@atosausa.com Service Tel: 1-855-855-0399 5