Page 1: Table Of Contents
Install & Operation Guide chilled Contents Page No Description Major Components Parts to Assemble Installation Water Connection Operation & Maintenance Performance Data Fault Diagnosis Guide Electrical Diagram General Safety Advice Maintenance & Removal...
Page 2: Major Components
Before using this machine, we advise you to read this manual thoroughly. Please follow the instructions for proper operation to prevent risk or damage. Major Components 1. Main Shell 11. Tank Insulation 19. Top Panel 2. Dust Cap 12. Front Panel 20.
Page 3: Parts To Assemble
Parts to Assemble The swan-neck installation instruction is as following: Sink Top Rubber Washer Washer and Spacer Pipe Connection Water Pipe Installation The following is a guide but the installer is responsible to comply with any local regulations that may be applicable to this type of installation. 1.
Page 4: Water Connection
Installation continued 5. Avoid tilting the machine during installation. necessary remove the sink top to carry this out. If the machine has been tilted excessively for (See page 3) more than a few minutes during or before installation, leave to stand for approximately 9.
Page 5: Operation & Maintenance
6. The thermostat is factory preset and should 8. Allow 1hr for the water to cool before not need further adjustment. the dispense water reaches its operational temperature. 7. Refit the Front panel. 10 c Operation & Maintenance 1. Frequently clean the fountain using warm 4.
Page 6: Fault Diagnosis Guide
Fault Diagnosis Guide Fault Possible Cause Suggested Action Not Cooling The compressor is not running Check the power is switched The power is on but not The thermostat is set too high Reduce the thermostat cooling temperature setting Water leakage The pipes or connections are Switch off power turn off water leaking...
Page 7: General Safety Advice
General Safety Advice Allow an air gap of at least 100mm on each side and at the front of the machine. 100mm Avoid areas exposed to excessive heat, humidity, rain or snow or direct contact with water spray or splashing. Avoid positions of direct sunlight or solar heat.
Page 8: Maintenance & Removal
Maintenance & Removal Please make sure the machine is completely Turn off the water supply. disconnected from electricity before carrying out any maintenance work. To drain the Direct Chill tank, remove the cap at the bottom of the tank. This is located behind the front panel.