Table of Contents
Advertisement
Wolfpack Component Video Matrix Switch
Installing the Cards
1) Put the ESD wrist strap on your wrist and attach the clip end to the
system chassis.
2) Remove 16 output card from it's ESD safe bag.
3) Install into the lowest numbered slot in the backplane board. Insert
edge connector in a straight down motion not angled. Push firmly to
ensure it is seated all the way.
4) Install 2 screws through the rear panel and into mounting brackets on
the 16 output card.
5) Replace the top cover, the 4 side screws, and the 5 rear flange screws.
Advertisement
Table of Contents
