Table of Contents
Advertisement
Wolfpack Component Video Matrix Switch
IR Inputs
Located on the front panel is a small box labeled ―IR Inputǁ where IR codes can
be received. If your system makes use of IR emitters from a control system, this
is the correct location to attach the emitter.
On the rear panel of the system is a pink colored 3.5mm jack labeled ―IRǁ. If
your control system supports it, you may alternately connect directly to the
matrix system. Note that this IR jack is for unmodulated IR codes, not simply IR
emitters converted to 3.5mm plugs. If your system is unable to remove the IR
modulation carrier, then attach the emitter to the front panel only.
Discrete IR Codes
The number of button presses required to route video can sometimes be too long
when automating the IR button presses in a complex macro program. To solve
this, a unique, or discrete IR code has been assigned to each input and each
output. Using this method, any switching function can be triggered by using
only two short IR codes.
For further information on programming of remotes and control systems,
contact us.
Power
Via Front Panel
A single touch of the power button turns the unit on. To prevent an
accidental power down, two button presses are required to shut down the matrix.
The power function disables all of the video outputs, however does not
completely power down the matrix system. Further power reduction can be
accomplished with ‗Eco Mode '. This feature can be set in the System Setup
Menu below.
Via IR Remote
There are three power buttons on the IR remote.
Power Toggle – Changes power state from current state
Power On – Always turns on, regardless of current state
Power Off – Always goes to standby, regardless of current state
Advertisement
Table of Contents
