Table of Contents
Advertisement
Hawk 2XL Product Manual, Rev. B
2.0
Applicable standards and reference documentation
The drive has been developed as a system peripheral to the highest standards of design and construction. The
drive depends upon its host equipment to provide adequate power and environment in order to achieve opti-
mum performance and compliance with applicable industry and governmental regulations. Special attention
must be given in the areas of safety, power distribution, shielding, audible noise control, and temperature reg-
ulation. In particular, the drive must be securely mounted in order to guarantee the specified performance char-
acteristics. Mounting by bottom holes must meet the requirements of Section 8.4.
2.1
Standards
The Hawk 2XL Family complies with Seagate standards as noted in the appropriate sections of this Manual
and the Seagate SCSI Interface Manual, P/N 77738479 (Vol. 2).
The Hawk 2XL Family is a UL Recognized component per UL 1950 and a CSA Certified component per CAN/
CSA-C22.2 No. 950-M89. It also meets the requirements of DIN VDE 0805/05.90 and EN60950: 1988 (IEC
950).
2.1.1
Electromagnetic compatibility
The drive, as delivered, is designed for system integration and installation into a suitable enclosure prior to
use. As such the drive is supplied as a subassembly and is not subject to Subpart J of Part 15 of the FCC
Rules and Regulations nor the Radio Interference Regulations of the Canadian Department of Communica-
tions. However, the unit has been tested using proper shielding and grounding and found to be compliant with
Class A limits of the FCC Rules and the Regulations of the Canadian Department of Communications.
The physical design characteristics of the drive serve to minimize radiation when installed in an enclosure that
provides reasonable shielding. As such, the drive is capable of meeting the Class B limits of the FCC Rules
and Regulations of the Canadian Department of Communication. However, it is the user's responsibility to
assure that the drive meets the appropriate EMI requirements in their system. Shielded I/O cables may be
required if the enclosure does not provide adequate shielding. If the I/O cables are external to the enclosure,
shielded cables should be used, with the shields grounded to the enclosure or to the host controller, but not
both.
2.1.2
Electromagnetic susceptibility
As a component assembly, the drive is not required to meet any susceptibility performance requirements. It is
the responsibility of those integrating the drive within their systems to perform those tests required and design
their system to ensure that equipment operating in the same system as the drive or external to the system
does not adversely affect the performance of the drive. See Section 5.1.1 and Table 2, DC power require-
ments.
2.2
Electromagnetic Compliance for the European Union
If this model has the CE Marking it complies with the European Union requirements of the Electromagnetic
Compatibility Directive 89/336/EEC of 03 May 1989 as amended by Directive 92/31/EEC of 28 April 1992 and
Directive 93/68/EEC of 22 July 1993.
Seagate uses an independent laboratory to confirm compliance to the above directives. The drive was tested
in a representative system for typical applications. The selected system represents the most popular charac-
teristics for test platforms The system configurations include:
• 486, Pentium, and PowerPC Microprocessors
• 3.5-inch Floppy Disc Drive
• Keyboard
• Monitor/Display
Although the test system with this Seagate model complies to the directives, we cannot guarantee that all sys-
tems will comply. The computer manufacturer or system integrator shall conform EMC compliance and provide
CE Marking for their product.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
3
Hide quick links:
Advertisement
Table of Contents
