Tuner record timer setting
This function enables you to set a timer for
starting and stopping ripping from the tuner
source automatically.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
1
Tune to the station you desire to record from.
(See "Radio Reception": "Tuning to radio stations"
and "Tuning to preset radio stations".).
2
Go to the standby mode. Then, Press and hold
CLOCK•TIMER on the remote control for
more than two seconds to select timer mode.
➜
The last timer setting starts flashing.
➜
The selected source will be lighted.
3
Press TUNER to select TUNER mode.
4
Press USB RECORD to enable USB recording.
➜
"ST" appears. "USB REC" and the hour and
minute digits for the start timer start flashing.
●
To cancel USB record setting, press USB
RECORD again until "ST" and "USB REC"
disappear.
➜
In this case, you can only continue to set the
system switch-on timer. (See "Clock/Timer":
"Timer setting".)
5
Press 5 or 6 repeatedly to set the hour for
the timer to start.
6
Press í or ë repeatedly to set the minute
for the timer to start.
➜
"ET" appears.
digits for the sleep timer (12 hours later than the
start timer by default) star t flashing.
7
Press 5 or 6 repeatedly to set the hour for
the timer to stop.
8
Press í or ë repeatedly to set the minute
for the timer to stop.
9
Press CLOCK•TIMER to store the set tuner
record timer.
➜
The ripping will start at the set start time and
end at the set stop time.
➜
The speakers will be muted.
and the hour and minute
External Sources
Notes:
– It is impossible to set a sleep timer more than
12 hours later than the start timer.
– During timer setting, if no button is pressed
within 60 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
●
Press TIMER ON/OFF on the remote control.
➜
disappears from the display.
To activate the TIMER
●
Press TIMER ON/OFF on the remote control.
➜
appears on the display.
To view the set record timer
1
In the standby mode, press and hold
CLOCK•TIMER on the remote control to
view the start timer setting.
2
Press CLOCK•TIMER on the remote control
again to view the sleep timer setting.
To view remaining time during ripping
●
After the tuner record timer starts, press
SLEEP on the remote control to view the
remaining time of ripping.
●
To cancel the sleep timer, press SLEEP
repeatedly until "00" appears.
27