2GIG-Z-BRDG-433
Z-Wave Energy Bridge
INSTALL INSTRUCTIONS
These instructions are for pairing the Z‐Wave Energy Bridge with a
Current Cost Transmitter and CT‐Clamps.
Box Contents
• Z‐Wave Energy Bridge
TIP:
Go to 2gig.dealer.com for instructions on how to use the Z‐
Wave Energy Bridge as a Lighting/Dimmer Module.
The CT‐Clamps and the Transmitter are sold separately.
NOTE:
(Step 1) Pair Transmitter and Z-Wave Energy
Bridge
1
Using the tip of a paper clip (or something smaller), press and hold
(up to 12 seconds) the small button on the front of the transmitter
(see Figure 1) until the red LED flashes once. Release the button
and the red LED will begin to flash rapidly.
2
While the red LED flashes, press
and hold the button on the Z‐
Wave Energy Bridge (see Figure 2)
while plugging it into an outlet.
This causes the green LED to flash
rapidly on the Z‐Wave Energy
Bridge.
The red LED light on the
3
transmitter and the green LED light on the Z‐Wave Energy Bridge
will continue to flash rapidly for about 60 seconds after which,
both LEDs will flash in sync about every 10 seconds, signalling that
the transmitter and the Z‐Wave Energy Bridge have been
successfully paired.
After 3 minutes, the LED on the Z‐Wave Energy Bridge will
NOTE:
stop flashing.
NOTE:
Install CT‐Clamps following the instructions that come in
the CT‐Clamp box.
CAUTION: All equipment must be installed by Licensed
Professionals.
(Step 2) Enable Z-Wave and Energy Feature
Settings
1
From the Control Panel's Home Screen, Press Security / Menu /
Toolbox. Enter the installer code.
2
Scroll right using the → arrow un l you see the Installer Toolbox
button. Press it.
From the Installer Toolbox, press System Configuration.
3
Press Go To to jump directly to a programming questions 79, 80
4
and 90. Make sure that the questions are set to the following:
• Set Question 79 to 3
• Set Question 80 to 1
• Set Question 90 to 2
5
Exit programming, by clicking end and exit. Upon exit, the panel
takes one to two minutes to reboot.
6
After the Control Panel reboots, from the Home Screen press
Services / Z‐Wave / Toolbox / Enter Installer Code / Add Devices.
Press the Z‐Wave Energy Bridge center button twice. The Control
7
Panel should display that the Z‐Wave Energy Bridge has been
learned in.
If the Z‐Wave Energy Bridge doesn't appear as a device
NOTE:
that has been learned in, remove the device and try re‐adding
it.
(Step 3) Program Energy Management Settings
From the Home Screen, press Services / Energy / Meter Settings.
1
2
Press ok.
3
From the Energy Screen, press Cost Settings. Input the cost (per
KWh) that is currently spent on electricity.
Press ok.
4
©2013 2GIG by Linear Corporation. All Rights Reserved.
1