Table of Contents
Advertisement
Speaker
(right)
AC power cord
IMPORTANT!
– The type plate is located at the
bottom of the system.
– The voltage selector located at the
bottom of this system is preset at
220V-240V from the factory. For
countries that operate at 110V-127V,
please adjust to 110V-127V before you
switch on the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
Connecting the speakers
1
Connect the two front speakers to the
SPEAKERS (8Ω) terminals with two speaker
cables. Right speaker to "R" and left speaker to
"L", red wire to "+" and silver wire to "-". Fully
insert the stripped por tion of the speaker wire
into the terminal as shown.
A
FM
MW antenna
antenna
2
Connect the passive subwoofer to the
WOOFER OUT (8Ω) terminal with the supplied
subwoofer cable by matching the plug types.
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the supplied
speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
B
Connections
Subwoofer
Speaker
(left)
7
Advertisement
Table of Contents
