4. CONNECTION METHOD TO
OUTDOOR CONTROL PC BOARD
•
Connect the connector to outdoor control PC board
•
Refer to figure for the connection method to outdoor
control PC board.
•
Connect the end of wire to the external circuit.
Extend with locally purchased wire if necessary.
If extended, insulate the connected part.
(Example)
To connect wire to CN206
(1) Please draw around the wire as shown in the figure, and
then fix it with clamp.
(2) Fix the Binder (accessory (outdoor unit)).
(3) Pass the wire through the as yet unused knockout hole.
(Please protect the wire with the edge of knockout hole
to avoid damage.)
Seal the knockout hole that passes the wire with putty,
so that there is no gap.
En-2
CN206 (Black) Base heater output
•
Do not bind this wire to other wires except the clamp
shown in (1).
(1) Clamp
Wire
CAUTION
(2)
(3)