Advertisement
WARNING:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
- Warning: Changes or modifications to this unit not expressly approved by the party respon-
sible for compliance could void the user's authority to operate the equipment.
- NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Care And Maintenance
1. Before using and reusing, inspect the product carefully. Discard any product that has cut,
damaged or frayed wire insulation cords, cracked lamp holders or enclosures, loose connec-
tions, or exposed copper wire.
2. Wipe the unit with a damp cloth and allow the unit to dry before storing.
3. When storing the product, carefully remove it from wherever it is placed, including trees,
branches, or bushes to avoid any undue stain or stress on the product conductors,
connections and wires.
4. When not in use, store neatly in a cool, dry location protected from sunlight.
Troubleshooting
Problem: The unit is not inflating.
- The power source is disabled or the cord may be unplugged. Check all power cables to make
sure that they are properly connected to a power source. Ensure that the power outlet has
power.
- Debris may be lodged in the motor. Unplug fan unit and remove any foreign objects or debris
from the motor.
NOTE: Periodically, the inflatable air-intake area may become clogged with grass, leaves or
other debris. For best results, it is recommended to check this air-intake area and clean as
necessary.
- Occasionally, the hanging fabric of a partially inflated inflatable can become attached to the
motor's air- intake area. Ensure that fabric is not hanging near the motor during inflation.
- The zippers that seal the inflatable may not be completely closed. Make sure the zipper is zipped
closed.
- The temperature may be below 14ºF (-10ºC). Remove the unit from extreme temperatures until
weather conditions improve.
- The connection between the inflatable and fan may not be securely attached.
Problem: The unit is torn.
- You may hand sew rips with any type of thread or use clear packing tape to cover the tear.
Problem: There is delay after plugging in the adaptor.
- This is a protective feature built in to these adapters to protect your electrical circuit and the
product. 2-3 seconds start up delay is normal.
Questions or Problems?
Visit our website www.toysinquiry.com or call our customer service department at
1-800-434-6178 for expedited assistance.
5
6
Advertisement
