Toro Power Clear 721 Operator's Manual page 21

2. Position the Quick Shoot control between the
2 arrows located on the right side of the upper
handle (Figure 35).
Figure 35
1. Arrows
3. Rotate the discharge chute so that it faces
straight ahead and the arrow on the back of the
discharge chute aligns with the arrow on the
shroud (Figure 36).
Figure 36
4. Hold the discharge chute in the straight-ahead
position, pull the lower cable casing downward
until you remove the slack in the cable, and
tighten the screw on the lower cable clamp
securely (Figure 37).
g006405
1. Lower cable casing
5. Pull the upper cable casing forward until you
remove the slack in the cable, and tighten the
screw on the upper cable clamp securely
38).
1. Upper cable casing
Note:
Do not over-tension the cables. If the
cables are over-tensioned, the Quick Shoot will
be hard to operate.
g286564
21
Figure 37
Figure 38
g286565
(Figure
g286566