Advertisement
Status display instructions
The repeater features a two-line, eight-character display. There is a low level backlight level that is always active and can only
be seen at night.
When left unattended after configuration, the repeater will display is currently assigned communication MAC address.
Repeater
28
Installer configuration parameter menu
Configuration is done locally at the repeater.
To enter configuration, press and hold the Left button for 8 seconds
Press again the Left button repetitively to scroll between all the available parameters
Use the (up / right) and (down / middle / center) key to change the parameter to the desired value.
To acknowledge and save the new value, press the Left button again.
The next listed parameter is now displayed
Configuration interface
Left
Middle / Center
Right
Configuration parameters
Default value
Com Addr
PAN ID
Channel
Enters the configuration mode. Press and hold for 8 seconds
Pressing repetitively will scroll all available parameters one by one
Adjust / rotate parameter value down
Adjust / rotate parameter value up
Repeater networking address
Default value = 254
Range is: 0 to 254Valid range is 0 to 254
Personal Area Network Identification
Default value = 0
Range is: 0 to 500
This parameter (Personal Area Network Identification) is used to link specific
controllers or repeaters to a single specific Viconics wireless gateway ( VWG /
JACE ) For every controller or repeater reporting to a gateway be sure you set the
SAME PAN ID value both at the gateway and the wireless device(s).
The default value of 0 is NOT a valid PAN ID. The valid range of available PAN ID
is from 1 to 500
Channel selection
Default value = 10
Range is: 10 to 26
This parameter (Channel) is used to link specific controllers or repeaters to
specific Viconics wireless gateway(s) ( VWG / JACE ) For every controller or
repeater reporting to a gateway be sure you set the SAME channel value both at
the gateway and the wireless device(s).
Viconics recommends using only the following channels ( 15, 25 or 26 )
The default value of 10 is NOT a valid channel. The valid range of available
channel is from 11 to 26
Significance and adjustments
6
Advertisement
