Advertisement
Repeater Status LED
Be sure all controllers and repeaters connected to a VWG and JACE are using the same PAN ID and Channel as
the JACE wireless communication card.
Repeater Wireless Adapter LED Status Indicators
1 x 200ms short blink
2 x 200ms short blinks
3 x 200ms short blinks
4 x 200ms short blinks
4 x 200ms short blinks and 1 x 1500ms long blink
System Troubleshooting Recommendations
1.
If a repeater is not detected by the VWG and JACE, verify that the LED is blinking at least 4 times. If it is only blinking twice,
ensure that the PAN and Channel of the controller is the same as the VWG and JACE it must communicate with.
2.
When commissioning a network, it is recommended to use channels 15, 25 or 26. Alternate these channels between floors.
3.
If a particular repeater or controller refuses to join the network and cannot be seen by the VWG and JACE. Please move
closer to the VWG and JACE until it has joined the network and it is added to the database. It can then be re-located to its
original position.
Terminal Block
Two wires power the repeater. No other wiring is required. Simply connect 24 Vac to the terminal block as shown below.
Power on
Power on and adapter communicating with repeater base
Power on, adapter communicating with repeater base and there is connectivity
to wireless network
Power on, adapter communicating with repeater base, connectivity to wireless
network and VWG / JACE is communicating with wireless repeater
Power on, adapter communicating with repeater base, connectivity to wireless
network and VWG is communicating with wireless repeater.
RC – 24 V ~ Hot
C – 24 V ~ Common
5
Advertisement
