Preparations; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The; Step 2: Setting The Clock - Philips MCD288/12 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the Remote Control
3
1
2
1
Open the battery compartment.
2
Insert two AAA batteries following the
indications (+/-) inside the compar tment.
3
Close the cover.
Using the Remote Control to operate
the Player
1
Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.
2
Do not put any objects between
the Remote Control and the
DVD Player while operating the
DVD Player.
CAUTION!
– Remove batteries if they are
exhausted or if the Remote Control is
not being used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Step 2: Setting the clock

1
Go to Standby mode.
2
Press and hold CLOCK/RDS on the remote.
➜ "CLOCK SET" is displayed briefly. Then, the
hour digits flash on the display screen.
3
Press VOLUME -/+ (VOL +/- on the remote)
to set the hours.
4
Press CLOCK/RDS again.
➜
The minute digits flash on the display screen.
5
Press VOLUME -/+ (VOL +/- on the remote)
to set the minutes.
6
Press CLOCK/RDS to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.

Preparations

21