Bimar S236 Instruction Booklet page 7

Fax +32 030 9904733
plug of the heater, have the outlet replaced with another more suitable type by professionally
qualified personnel, who will make sure that the section of the wires of the outlet is appropriate for
the absorbed power of the heater. Check that the mains are not connected equipment; high
absorption to prevent overloading and fire risks. Check that the mains are not connected
equipment; high absorption to prevent overloading and fire risks. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
heater.Attention: before use the appliance remove the detachable coupon to stick the handle.
• The heater must only be used if secured to a wall: the wall must be flat, smooth, very stable (as the
appliance could tip over) and heat resistant. The heater must be positioned in a way that: -The air
exit grill has a minimum of free space of 100 cm., while to the sides, the free space must be at least
40 cm.; -The intake part beneath the cover "A" must be free from obstacles (covers, curtains, etc.)
which could limit the air inflow causing appliance overheating or damage; -It is well-removed from
other sources of heat; -Far away from baths or showers to prevent water droplets or steam from
affecting it.
• Position the fan heater far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat.
If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-resistant
material (not of wood or synthetic material which rapidly heats up); follow the indications below for
installation:
- The heater must be installed at least 1,8 m above the floor; fit using the two "lock hole slots" in the
rear panel: make two holes in wall 46cm. apart, at a height of at least 200 cm. from the floor and
perfectly horizontal; insert expansion wall anchors into the same and screw in round-head 8 mm.
diameter screws suitable for the slots (see fig. 1)
• If
fixed in
to be installed so that switches and other controls cannot be touched by a person in the bath or
shower.
• Warning: don't use wet hand touch the working machine and don't cover the wind outlet and inlet.
• Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Make sure that the fan heater is working correctly: if not, turn the heater off and have it checked by
professionally qualified personnel.
• Make sure that the air-intake grid is not obstructed by objects, fabrics or anything else to avoid the
heater overheating or breaking.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
a bathroom shall
7 20
/
Assembly page 7/20
state that the heater is