Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips MCM204/12 User Manual

Radio Reception

Tuning to radio stations

1
Select TUNER source.
2
Press SOURCE on the set repeatedly or press
TUNER on the remote repeatedly until the
desired waveband (FM or MW) is displayed.
3
Press down on TUNING 4 ¢ and release
button.
➜
The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
4
Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING 4
¢ briefly and repeatedly until you have found
optimal reception.

Programming radio stations

You can store up to a total of 40 radio stations
in the memory.

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only programme
stations which are not in the memory already.
1
Press ALBUM/PRESET 4 3 to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
16
2
Press PROG for more than 2 seconds to
activate programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength. The first preset automatically stored will
then be played.

Manual programming

1
Tune to your desired station (see Tuning to radio
stations).
2
Press PROG to activate programming.
➜
flashes in the display.
PROG
3
Press ALBUM/PRESET 4 3 to allocate a
number from 1 to 20 to this station.
4
Press PROG again to confirm the setting.
➜
disappears, the preset number and the
PROG
frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.

Tuning to preset radio stations

●
Press ALBUM/PRESET 4 3 until the desired
preset station is displayed.