Basic Functions; Plug And Play (For Tuner Installation); Switching The System On; Power-Saving Automatic Standby - Philips MCM204/12 User Manual

Basic Functions

M I C R O S Y S T E M M C M 2 0 4
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
Press ÉÅ on the system to start installation.
➜ "PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
The system will automatically store the radio
stations with sufficient signal strength, starting
from FM, and followed by MW band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and holdÉÅ on the
system until "AUTO INSTALL - PRESS PLAY"
is displayed.
2
Press ÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
12
ALBUM/
(for tuner installlation)
To exit without storing the Plug and Play
● Press 9 on the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.

Switching the system on

●
Press STANDBY ON
SOURCE (or 2on the remote control).
➜
The system will switch to the last selected
source.
●
Press CD, TUNER or TAPE on the remote
control.
➜
The system will switch to the selected source.
To switch the system to standby mode
●
Press STANDBY ON
system (or 2on the remote control).
●
If in tape mode or recording mode, press
STOP•OPENÇ0 first.
➜
The volume level (up to a maximum volume
level of 20), interactive sound settings, last
selected source and tuner presets will be
retained in the player's memory.
To switch the system to Eco-power
standby mode
● Press and hold STANDBY ON
(or y on the remote control) for more than 2
seconds.
➜ The display will go blank.

Power-saving automatic standby

The power-saving feature automatically switches
to standby 15 minutes after a CD playback has
ended and no control is operated.
or
ECO POWER
on the
ECO POWER
ECO POWER