Symbols And Safety Warnings; Main Components; Assembly - EMAK Efco PTX 2710 Original Instructions Manual

obstacle. Wear adherent anti-cut clothing.
Anti-cut jackets, dungarees and leggings
are ideal. Do not wear clothes, scarves, ties or
bracelets that can stuck into woods or twigs.
Tie up and protect long hair (example with
foulards, cap, helmets, etc.)
Safety shoes or boots having skid-proof
sole and anti-piercing insert.
Wear protective helmet.
Use protections against noises; for example
noise reduction ear guards or earplugs.
The use of protections for the ear requests
much more attention and caution, because
the perception of danger audio signals
(screamings, alarms, etc.) is limited. Always
remove ear protectors as soon as the engine
has been switched off.
Wear anti-cut gloves.
2. SYMBOLS AND SAFETY WARNINGS (Fig.15)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
3. Wear strong boots and gloves.
4. WARNING! – The surface can be hot!
5. Purge Bulb.
6. The machine is not electrically insulated
to avoid contact with high voltage lines.
Never approach the device at less than 10
metres from electric lines. Keep bystanders
away 15 m.
7. Type of machine: POLE PRUNER.
8. Guaranteed sound power level.
9. CE conformity marking.
10. Serial number.
11. Year of manufacture.
3. MAIN COMPONENTS (Fig.1)
1÷3. Tools supplied
4. Harness
5. Fuel tank cap
6. Purge Bulb
7. Muffler guard
8. Spark plug
9. Air filter
10. Starter Handle
11. Choke Lever
12. Throttle trigger lockout
13. STOP button
14. Throttle lever
15. Harness attachment
16. Shaft arm
17. Button half-throttle
18. Cutting implement
19. Bar
20. Chain
21. Oil tank
22. Oil filler cap
23. Adjustable bevel drive
24. Bevel drive lock/release screw
25. Bar clamp nuts
26. Chain adjustment screw
27. Chain guard

4. ASSEMBLY

Cutting device assemblage
Put the shaft arm (A, Fig.2) in the cutting
implement (B), till the centering hole on the shaft
matches that of the implement.
Fix the centering screw (C, Fig.2) first and then the
two screws (D, Fig. 2).
PREPARING TO WORK
Harness
Correct adjustment of the harness permits the
pole pruner to be properly balanced and at an
appropriate height from the ground (Fig. 4).
- Put on the single harness (Fig. 5).
- Hook the pole pruner to the harness using the
hook (A, Fig. 6).
- Position the buckle (C, Fig. 7) to obtain the
correct pole pruner height.
GB
21