Table of Contents
Advertisement
4 Get started
Caution
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
Before you press any function button on the
with the remote control.
If you are not going to use the remote control
for a long time, remove the battery.
Set clock
1
In the standby mode, press and hold
CLOCK to activate the clock setting
mode.
»
The hour digits are displayed and begin
to blink.
2
Press + VOL - to set the hour, then press
CLOCK again.
»
The minute digits are displayed and
begin to blink.
3
Press + VOL - to set the minute.
4
Press CLOCK
setting.
Turn on
1
Press
.
»
The unit switches to the last selected
source.
Switch to standby mode
1
Press
again.
»
The clock (if set) appears on the
display panel.
Find the correct viewing
channel
1
Press
to turn on the unit.
2
Press DISC to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
Go to the lowest channel on your
TV, then press the Channel Down
button until you see the blue screen.
Press the source button repeatedly
on the remote control of your TV.
EN
15
Advertisement
Table of Contents
