thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
Warning:
instruction
Hot surface
manual
1. saFetY
1.1.
electrical saFetY
Warning! electrical installation of compressor to a 3-phase 415volt supply must only be carried out by a qualified electrician.
make sure the power supply cable is correctly connected to the earth. it is the responsibility of the owner/operator to read and understand
and comply with the following. You must check all electrical equipment and appliances to ensure they are safe before using. You must
inspect power supply leads, plugs and all electrical connections for wear and damage. You must ensure the risk of electric shock is
minimised by the installation of appropriate safety devices. An rccB (residual current circuit Breaker) should be incorporated in the
main distribution board. You must also read and understand the following instructions concerning electrical safety.
1.1.1.
the Electricity At Work Act 1989 requires all portable electrical appliances, if used
on business premises, to be tested by a qualified electrician, using a Portable Appliance Tester
(PAT), at least once a year.
1.1.2.
the Health & Safety at Work Act 1974 makes owners of electrical appliances responsible
for the safe condition of the appliance and the safety of the appliance operator. if in any doubt
about electrical safety, contact a qualified electrician.
1.1.3.
ensure that all insulation on the cables and the appliance itself is safe before connecting
to mains power supply.
1.1.4.
ensure that cables are always protected against short circuit and overload.
1.1.5.
regularly inspect power supply, leads, plugs and all electrical connections for wear and damage,
especially power connections, to ensure that none are loose.
1.1.6.
important: ensure the voltage marked on the product is the same as the electrical power
supply to be used. A three phase plug must be fitted to this machine.
do not pull the powered appliance by the power cable.
8
do not pull power plugs from sockets by the power cable.
8
do not use worn or damage leads, plugs or connections. immediately replace or have repaired by a qualified electrician.
8
© Jack sealey limited
instructions for
compressors 270ltr belt drive 5.5/7.5 hp 3 ph
2-stage
model no:
Warning:
Wear ear
electricity
protection
Original Language Version
sac42755bln, sac72775bln
Wear eye
Wear protective
protection
clothing
1.
2.
3.
4.
5.
6.
sAc42755Bln, sAc72775Bln
Warning:
Automatic
startup
direct compressed Air outlet
tank
On/Off/Reset Switches
Pressure Gauge
Hour meter
condensate drain tap
issue 3 (H, f) 02/03/18