Other Functions
Radio Reception
Tuning to radio stations
1
Press STANDBY-ON B (B on the remote)
to switch on the last selected source.
2
Press SOURCE (TUNER on the remote) to
select FM mode.
3
Press and hold 1 / 2 on the remote until the
frequency indication starts to change, then
release.
➜
The system automatically tunes to the next
strong radio station.
●
To tune to a weak station, press 1 / 2 on the
remote briefly and repeatedly until an optimal
reception is found.
4
Repeat Step 3 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 20 stations regardless of
the reception.
Automatic programming
●
Press PROGRAM on the remote for more
than two seconds to activate programming.
➜
All available stations are programmed.
Manual programming
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROGRAM on the remote.
➜
"PROG" icon flashes.
3
Press ¡ / ™ to select the desired preset
number.
➜
If "PROG" icon goes off before you select the
desired preset number, press PROGRAM on
the remote.
4
Press PROGRAM on the remote again to
store the radio station.
●
Repeat steps 1-4 to store other radio stations.
34
Listening to preset radio stations
●
In tuner mode, press ¡ / ™ to select the
desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1
In Standby mode, press and hold CLOCK/RDS
on the remote until the time flashes on the
display.
➜
"CLOCK" is displayed briefly. Then, the hour
digits flash on the display screen.
2
Press VOLUME +/ - (VOL+/- on the remote)
to set the hours and CLOCK/RDS to
confirm.
➜
The minute digits flash on the display screen.
3
Press VOLUME +/ - (VOL+/- on the remote)
to set the minutes and CLOCK/RDS to
confirm.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.