Other Functions
Radio Reception
Tuning to radio stations
1
Press STANDBY-ON y to switch on the last
selected source.
2
Press SOURCE (TUNER on the remote
control) to select TUNER (FM) mode.
3
Press and hold ¡ / ™ (or 2/3 on the remote
control) until the frequency indication starts to
change, then release.
➜
The system automatically tunes to the next
strong radio station.
●
To tune to a weak station, press ¡ / ™ (or 2/3
on the remote control) briefly and repeatedly
until an optimal reception is found.
4
Repeat Step 3 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations regardless of
the reception.
Automatic progamming
●
Press PROGRAM on the remote for more
than two seconds to activate programming.
➜
All available stations are programmed.
Manual progamming
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROGRAM on the remote.
➜
"PROG" icon flashes.
3
Press PRESET+ or PRESET -/9 (or ¡ / ™ on
the remote control) to select the desired preset
number.
➜
If "PROG" icon goes off before you select the
desired preset number, press PROGRAM on
the remote.
4
Press PROGRAM on the remote again to
store the radio station.
●
Repeat steps 1-4 to store other radio stations.
32
Listening to preset radio stations
●
In tuner mode, press PRESET+ or PRESET -/
9 (or ¡ / ™ on the remote control) to select
the desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜
"CLOCK SET" is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3
Press CLOCK to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Setting sleep/wake-up timer
Sleep timer setting
In power-on mode, the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
1
In power-on mode, press SLEEP/TIMER on
the remote repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
00 ➜ 10 ➜ 20 ➜ 30 ➜ 40 ➜ 50 ➜ 60 ➜ 70
➜ 80 ➜ 90 ➜ 00
2
When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜
"SLEEP" appears.