Ganz G2 THERMAL ZNT1-P Series Installation Manual page 8

ZNT1-­‐P S eries
Safety
Wire
To p revent p roducts f rom d amage, p lace t he c amera o n s table a nd n on-­‐ v ibrating
!
surfaces. I f t he s tability i s i n d oubt, c onsult s afety p ersonnel f or r einforcements,
and t hen p roceed w ith t he i nstallation.
Caution
8) Before a ttaching t he c amera's m ain b ody, m ake
sure t he s afety b y c onnecting t he s afety w ire f rom
the t op c ap t o t he s afety w ire h older o n t op o f t he
camera's m ain b ody.
9) Connect a ll t he n ecessary c ables f rom t he c eiling
to t he c orresponding c onnectors o n t he m ain b ody
by r eferring t o 5 . C ONNECTIONS.
10) Insert t he m icroSD/SDHC c ard i nto t he c ard s lot
if n ecessary.
11) Close t he t op c ap o f t he c amera b y t wisting i t
counter-­‐clockwise a nd m aking t he a lignment m arks
both o n t he t op c ap a nd t he c amera b ody a ligned t o
the c losed p adlock m ark o n t he t op c ap.
CBC A merica L LC.
ZNT1-P Installation Guide
8