Table of Contents
Advertisement
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.
Auto install radio stations
When you connect the unit to the power
supply for the first time, or no radio station is
stored in this unit, Plug and Play is activated to
store all available radio stations automatically.
1
Connect the unit to the power supply.
»
[AUTO INSTALL - PLEASE PRESS
PLAY, STOP CANCEL] (auto install -
press the PLAY button; to cancel, press
) is displayed.
2
Press
on the main unit to start
installation.
»
[AUTO] (auto) is displayed.
»
The unit automatically store radio
stations with sufficient signal strength.
»
When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.
Set clock
1
Press and hold CLOCK/DISPLAY to
activate the clock setting mode.
»
The 12 hour or 24 hour format is
displayed.
2
Press PROG repeatedly to select 12 hour
or 24 hour format.
3
Press CLOCK/DISPLAY to confirm.
»
The hour digits are displayed and begin
to blink.
4
Press
/
to set the hour.
5
Press CLOCK/DISPLAY to confirm.
»
The minute digits are displayed and
begin to blink.
6
Press
/
to set the minute.
7
Press CLOCK/DISPLAY to confirm.
Tip
•
To view the clock during play, press
DISPLAY repeatedly until the clock is
displayed.
Turn on
1
Press POWER.
»
The unit switches to the last selected
source.
Switch to standby
1
Press POWER to switch the unit to
standby mode.
»
The backlight on the display panel is
dimmed.
»
The clock (if set) appears on the
display panel.
CLOCK/
EN
11
Advertisement
Table of Contents
