Table of Contents
Advertisement
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
‡
If you are not going to use the remote control for a
long time, remove the batteries.
‡
Do not use old and new or different types of batteries
in combination.
‡
Batteries contain chemical substances, so they should
be disposed of properly.
Connect power
Caution
‡
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the rear of the main unit.
‡
Before connecting the AC cord, make sure that you
have completed all other connections.
Note
‡
The type plate is located on the rear of the main unit.
1
Connect the AC power cable to the AC
outlet.
Downloaded From DvDPlayer-Manual.com Philips Manuals
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY
KEY](auto install - press play key) is
displayed.
2
Press
on the main unit to start
installation.
» The unit automatically stores radio
VWDWLRQV ZLWK VXIÀFLHQW VLJQDO VWUHQJWK
» When all the available radio stations
DUH VWRUHG WKH ÀUVW SUHVHW UDGLR VWDWLRQ
is broadcast automatically.
Set clock
Note
‡
You can set the clock in standby mode only.
1
Press
to switch the unit to standby.
‡
Make sure that --:-- (or clock) is
displayed (see "Turn on" > "Switch to
standby").
2
Press and hold PROG/CLOCK SET to
activate the clock setting mode.
» SET CLOCK is displayed.
» The 12 hour or 24 hour format is
displayed.
3
Press
/
to select 12 hour or 24
hour format.
4
Press PROG/CLOCK SET.
» The hour digits begin to blink.
5
Press
/
to set the hour.
6
Press PROG/CLOCK SET.
» The minute digits begin to blink.
7
Press
/
to set the minute.
8
Press PROG/CLOCK SET WR FRQÀUP
EN
11
Advertisement
Table of Contents
