Get Started; Prepare The Remote Control; Auto Install Radio Stations; Set Clock - Philips FWM6500 User Manual

4 Get started

Caution
‡
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
VHTXHQFH
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Note
‡
Risk of explosion! Keep batteries away from heat,
VXQVKLQH RU ÀUH 1HYHU GLVFDUG EDWWHULHV LQ ÀUH
‡
Danger of explosion if battery is incorrectly replaced.
5HSODFH RQO\ ZLWK WKH VDPH RU HTXLYDOHQW W\SH
To replace the remote control battery:
1
Open the battery compartment.
2
Insert two AAA batteries (not supplied)
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
11 EN
Note
‡
If you are not going to use the remote control for a
long time, remove the batteries.
‡
Do not use old and new or different types of batteries
in combination.
‡
Batteries contain chemical substances, so they should
be disposed of properly.

Auto install radio stations

When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY] (auto
install - press the PLAY button) is
displayed.
2
Press on the main unit to start
installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
VWDWLRQV ZLWK VXIÀFLHQW VLJQDO VWUHQJWK
» When all the available radio stations
DUH VWRUHG WKH ÀUVW SUHVHW UDGLR VWDWLRQ
is broadcast automatically.

Set clock

1
In the standby mode, press CLOCK to
activate the clock setting mode.
» The 12 hour or 24 hour format is
displayed.
2
Press ALB/PRESET+/- repeatedly to select
12 hour or 24 hour format.
3
Press CLOCK WR FRQÀUP
» The clock digits are displayed and
begin to blink.
4
Press ALB/PRESET+/- to set the hour.
5
Press / to set the minute.