Monitor Mode; Main Menu - Honeywell VXP System Maintenance Manual

System Operations
5. Enter the ID number of the aircraft or select the desired ID number from the drop
down menu, and click on OK (or press the Enter key).
6. The Select Procedure window of the AP will display (Figure 3-4).
7. Select the desired procedure from the Select Procedure menu.
Information on how to test and balance aircraft are contained in the User's Guide and the on-line
manuals that come with each VXP system. The User's Guides and the on-line manuals are written
for specific aircraft and procedures can vary depending on the application and aircraft. The on-line
manual can be accessed by choosing Help from the menu line at any time.

3.2.2 Monitor Mode

The VXP can be configured to continuously collect vibration data in flight by uploading a monitor
route in a vmssetup.cfg file to the AU. If the VXP has been configured this way, the vibration
monitor will run under the following conditions:
1. Power is applied to the AU.
2. A valid magnetic pickup is connected to the channel specified in the setup file.
3. The serial communication between the PC and AU is not active.
Refer to the on-line application help or contact Product Support for more information.
3-6 Honeywell
Figure 3-3. AU Aircraft ID Dialog Box
Figure 3-4. Main Menu