Chapter 6. Shipping And Storage; Repacking; Shipping; Storage - Honeywell VXP System Maintenance Manual

Shipping and Storage
6.
The VXP comes in a protective case that is suitable for shipping and storing of the entire unit. The
case is environmentally sealed when closed, which makes it suitable for long-term storage as well.
There are sufficient storage places in the case to store the system.
Occasionally, however, it may be necessary to ship or store individual parts outside of the unit. If
you must return a part to Chadwick-Helmuth for repair, the part must be packed so that no damage
will occur during shipping.

6.1 REPACKING

Install major components, cables and accessories in the carrying case. Each component fits in a
specific place in the foam insert. The cables are stored under the divider attached to the top of the
carrying case.

6.2 SHIPPING

These instructions for shipping are only for returning any components to the manufacturer. All
components should be shipped so that no damage will occur. The VXP case with its contents
should never be shipped via commercial shipping methods.
To ship an individual component for repair, store as follows:
1. Place component to be shipped in a polyethylene bag, and pack in a fiberboard
container.
2. Mark container with part number, serial number, date of shipment and your complete
address.
3. Pack the fiberboard component container in an approved shipping container, and
ship using approved shipping methods.

6.3 STORAGE

The storage instructions pertain only to the long term storage of individual components kept as
spares in the event that a major component must be repaired.
If the component being stored is one that has been returned to you after repair, the best storage is
to keep it in the packing that it came in until needed.
Chapter 6
VXP System Maintenance Manual 6-1