Omega Research & Development Excalibur Quick Start Operation Manual page 2

REMOTE START FUNCTIONS
FUNCTION VALET BUTTON
Press 2x after Engine Running For
This will leave the engine running for the programmed run time (XL mode runs for 12 hours) so you can take your
Pit Stop Mode 2
More Than 10 Seconds
keys with you to run errands.
(Press 6x for XL mode)
Low Battery & Low/
Ignition Key ON, OFF, Press 2x
Auto-start will activate a max of once per 2 hours. See your installer or the full manual for threshold settings.
Hi Temp Auto-Start
This disables remote start and the security system. The status LED will turn on. Repeat this process or press valet
Valet Mode
2 Unlock, Hold For 3 Sec.
button once to exit valet mode. TIP: You can also enter valet mode by holding the valet button for 3 seconds!
MANUAL TRANSMISSION RESERVATION MODE
2
This must be performed before you can remote start a manual transmission vehicle to ensure the car is in neutral &
maximum safety. Consult your installer for more information.
1) With the engine running (more than 10 seconds), hold the brake pedal & place the transmission in neutral.
2) Apply the parking brake and release the brake pedal.
3) Send the remote start command via your remote. The remote start should engage
(not crank) and the status LED will begin flashing.
4) Take the ignition key out of the switch (the engine should stay running).
5) Exit the vehicle and lock your doors with the remote. The engine will turn off.
2-These functions are only available on some remote start models. Consult your installer for more info.
2
1-Button 2-Way LED Remote Start Systems
QUICK START OPERATION GUIDE
NOTE
WINDOW-MOUNT ANTENNA/RECEIVER
Valet / Programming Button Status LED
OTHER 2-WAY CONTROLLER FUNCTIONS
LED
FUNCTION BUTTON(S)
CONFIRMATION
Low Car
Alerts when battery level is below 11.5v
- 4 Beeps
Battery Alert for over 30 seconds.
Out Of Range - 4 LED Flashes
When command response is not received
2-WAY CONTROLLER OPTIONS
FEATURE PROCEDURE
Controller will scroll through:
Beep Volume Hold for 7 seconds.
Melody > Soft Melody > Silent
Scan to register
& download the
full operation
guide at
CarAlarm.com!
1-Button 2-Way LED Remote Start Systems
QUICK START OPERATION GUIDE
REMOTE START ERRORS
3
CHIRPS/FLASHES VIOLATED ZONE
NOTE
LED ON System in Valet mode
1 Hood opened
2 Brake pedal pressed
3 Bad tach signal or engine over-rev.
4 BLACK/WHITE wire lost ground
5 3D motion detected while cranking
6 Received engine stop command
7 Alarm was triggered
8 Run time expired
9 Low vehicle battery voltage detected
If the system fails to remote start or remote start stops unexpectedly,
it will give a long horn/siren chirp followed by a series of short horn/
siren chirps & light flashes. The short chirps/light flashes indicate
the cause of the failure.
TIP: If remote start won't activate, the system may be in valet mode
(Status LED ON). Press the valet button once to exit.
3-These functions are only available on some remote start models.
3