Omega Research & Development Omegalink Quick Start Operation Manual page 2

REMOTE START FUNCTIONS
BUTTON(S) CONFIRMATION
FUNCTION
Engine Start/Stop
x 2 Melody + LED flash
Run Time Extender*
Beep + LED flash
Auto Start Mode*
& &
Beep + LED flash
WINDOW-MOUNT ANTENNA/RECEIVER
Valet / Programming Button
*All functions are dependent upon vehicle & system availability. Consult your installer to confirm feature availability.
2
5-BUTTON LED 2-WAY
QUICK START OPERATION GUIDE
NOTE
Upon sucessful start, the remote will beep 4x and the Start LED will flash every 5 seconds during the programmed
runtime. Take Over*: Enter the vehicle and turn ignition key 'ON' then press the brake pedal.
The runtime will reset (only allowed once per remote start cycle).
1 beep for Auto Start Mode On / 2 beeps for Auto Start Mode Off.
Remote starts your vehicle every 2, 3, or 4 hours (programmable) or upon temperature threshold.
Status LED
Status LED
OTHER CONTROLLER FUNCTIONS
FUNCTION BUTTON(S) CONFIRMATION
Remote Valet Hold & for
+ LED flash
3 sec
Multi-Car LED flash
Hold & for +
3 sec 1x =car 1/2x = car 2
&
Hold for
Button Lock
&
LED will flash 4x
3 sec
,
Beep + LED flash 1x
x 2 ,
Beep + LED flash 2x
x 3 ,
Beep + LED flash 3x
& Beep + & LED flash
*All functions are dependent upon vehicle & system availability. Consult your installer to confirm feature availability.
5-BUTTON LED 2-WAY
QUICK START OPERATION GUIDE
NOTE
This disables remote start and the security system. The status LED will turn on. Repeat this process or press valet
button once to exit valet mode.
The LED flash upon any button press will indicate current car setting. Repeat to return to car 1.
1 flash = car 1 / 2 flash = car 2
When button lock is on the remote will not transmit. When any button is pressed the correspnidng LED will flash rapidly
uopn button press.
AUX1 - Write function in "FUNCTION" column
AUX2 - Write function in "FUNCTION" column
AUX3 - Write function in "FUNCTION" column
AUX4 - Write function in "FUNCTION" column
3