Table of Contents
Advertisement
Operating
PITSAN
Instructions for
Electrical Heater Units
Page 4 / 16
- Check out the fuses carefully. Beware of the sufficient power and amperage.
- A disconnecting means and ground must be provided in accordance with the National
Electrical Code.
- An optional integral thermostat may be installed to control heating element and fan. If so
equipped, the thermostat range is approximately 55°F to 105°F.
- Check out the contactor if it is working properly in threephase models.
Hot Furface: The surface temperature of the heater may rise up to temperatures which will
cause inquiry. Do not touch the surface while the heater is operating. In case of maintenance
or contact must, wait at least 2 hours after the unit is disconnected for the unit cool down .
2.2. Correct use
Heater will not operate.
• Make sure installation instructions and wiring diagram were followed.
• Disconnect switch or main circuit breaker may be in off position.
• Check for proper control voltage.
• Automatic or manual reset thermal cutout(s) may have opened due to overheating. Let unit
cool before resetting manual cutouts. Determine and correct the cause for overheating.
The unit is designed for heating air in closed areas. Do not intent to use the unit for other
applications.
PİTSAN MAK. SAN. VE TİC. LTD ŞTİ, Esenyurt Yolu Üzeri No: 66 - 68 Bağlar Mevkii, TR – 34850 Avcılar - İSTANBUL
Tel.: 0212/4281885, Fax: 0212/4281661, Email:pitsan@pitsan.com,
http: //www.pitsan.com
Advertisement
Table of Contents
