Tape Operation/Recording; Tape Playback; Rewinding / Fast Forwarding; General Information On Recording - Philips MCM510/25 User Manual

Tape Operation / Recording
ECO POWER
STANDBY - ON
M C M 5 1 0 M I C R O S Y S T E M
iR
ALBUM PRESET / TUNING
TIMER SET
SOURCE PROGRAM DSC

Tape playback

1
Select TAPE source.
➜
The display shows "TAPE
tape counter 000 is displayed.
2
Press OPEN/CLOSE ç to open the tape
door.
3
Insert a recorded tape and close the tape door.
●
Load the tape with the open side downward and
the full spool to the left.
4
Press É Å to start playback.
To stop playback
●
Press Ç.
To reset the tape counter display
●
In stop mode, press Ç once.
16
BAND CLOCK SET
RECORD DISPLAY RDS
VOLUME
DBB
INCREDIBLE
SURROUND
OPEN/
CLOSE
TAPE" briefly, and the
TAPE TAPE
TAPE

Rewinding / Fast forwarding

1
Press TUNING S/T (à/á on the
remote control).
➜
The tape will stop automatically at the end of
rewinding or fast forwarding.
➜
During fast winding, you can monitor the tape
message with the tape counter.
2
Press Ç to stop rewinding or fast forwarding.
General information on
recording
●
For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
●
The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND or DBB will not affect the
recording in progress.
●
At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
●
To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
IMPORTANT!
Recording is permissible if copyright or
other rights of third parties are not
infringed upon.