Kenwood NX-5000 Initial Setup Manual page 15

4. Assemble Remote Configuration
1. Set DIP switches of each RF Deck and Control Heads as shown in the provided diagrams on next page.
[Deck No. reflects how they are displayed on the control head.]
2. Connect all necessary KCT-71 cables between RF Decks and Heads as shown in the provided diagrams on next page.
3. Install accessories such as KAP-2, KCT-72 if they are needed.
(The Service Manual for each model describes the installation and pin position.)
Page | 15
NX-5000 Remote Configuration [Initial Setup Instruction]