Stabilizer Male Section - Summit Dual Performer Manual

STABILIZER BAR
1. Position the Female Section of the Stabilizer bar as
shown in figure 24. The Stabilizer bar will attach to the
welded U Bracket. Slide the bar into the bracket and
line up the hole.
2. Secure using one 1 3/4" bolt and lock
(see figure 25) Do not overtighten.
3. Position the Male Stabilizer bar as shown (figure 26).
Line up the bolt holes and secure using the
as shown in figure 27. The Stabilizer bar has several
pin
holes to accommodate different tree sizes.
24
26
STABILIZER
FEMALE SECTION
STABILIZER
MALE SECTION
(PN 82064.940)
PG 8
nut.
Wire Lock
STABILIZER
FEMALE SECTION
(PN 82064.950)
U BRACKET
1 3/4" BOLT, LOCK NUT -
WRENCH TIGHTEN
25
1/4" WIRE LOCK PIN
27
www.summitstands.com