Table of Contents
Advertisement
Connections
IMPORTANT!
– The type plate is located at the
bottom of the system.
– For users in the U.K.: please follow the
instructions on page 2.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
Step 1: Placing speakers
Front
speaker
( left )
VIEWING AREA
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV set.
– Allow adequate ventilation around the DVD
System.
Step 2: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
– A SCART connection allows you to
use features both Audio and Video
features on the DVD Player.
10
Using SCART jack
Front
speaker
●
( right )
Use the SCART cable (black) to connect the
DVD Player's SCART jack to the
corresponding Scart input jacks on the TV (cable
not supplied).
Note:
– Ensure that the "TV" indication on SCART cable
is connected to the TV set and "DVD" indication on
SCART cable is connected to the DVD Player.
Using Composite Video jack
1
Use the supplied composite video connectors
(yellow) to connect the DVD system's VIDEO
OUT jack to the video input jack (or labeled as
A/ V In, CVBS, Composite or Baseband) on the
TV.
2
To hear the TV channels through this DVD
system, use audio cables (white/red) to connect
AUX IN (L/R) jacks to the corresponding
AUDIO OUT jacks on the TV.
S-VIDEO
IN
AUDIO
TV IN
IN
VIDEO IN
S-VIDEO
IN
AUDIO
TV IN
IN
VIDEO IN
Advertisement
Table of Contents
