Operation - NightStick XPR-5572RM Instruction Manual

NOTE: The battery carrier cover will only fit one
way. It is not possible to install it in a reversed
position.
The Nightstick 5570-BATT Non-Rechargeable
Battery Carrier is ready to install into the Angle Light.
Installation of the 5570-BATT Non-Rechargeable
Battery Carrier into the Angle Light is the same
as installing the 5572-BATT Lithium-ion Battery
Pack. Please see the instructions listed above in
the 5572-BATT LITHIUM-ION RECHARGEABLE
Image 11
BATTERY PACK section.
PLACING THE ANGLE LIGHT INTO THE CHARGER
The Nightstick 5572-CHGR1 charger is designed to securely hold a
properly installed XPR-5572RM Angle Light in place under conditions up to
and including 9g of lateral force meeting the requirements of NFPA 1901
(2009).
WARNING: Installing the Angle Light into the charger MUST be done
using the following steps. Failure to do so could damage the charger or
its ability to hold the Angle Light securely in place.
The spring-loaded grips located on the charger, are designed to snap
around the body of the light one at a time...not simultaneously.
y While positioned in front of the charger, grasp the Angle Light around the
Image 12
bezel and place either the left or right side of the light into the charger at an
approximate 45 degree angle being certain that the base of the light rests
on the base contour of the charger. (Image 12)
y While holding the inserted side of the light against the back of the charger's
contour, firmly press straight back on the opposite side of the light (allowing
the edge to slide around the contour of the charger) until it slips past the
Spring-loaded Gripper and snaps into the charger. (Image 13)
WARNING: Attempting to push the Angle Light straight into the charger
or from an angle above or below, could result in damage to the charger
and should not be attempted.
Confirmation of proper installation can be seen in the LED Charge
Indicator Light. When the Angle Light is properly installed in the charger, and
power is being supplied by the Nightstick AC or DC Power Supply, the LED
Charge Indicator Light on the charger will light up constant RED indicating
that the unit is being charged. (Image 14)
Image 15
REMOVING THE ANGLE LIGHT FROM THE CHARGER
y While positioned in front of the charger, grasp the Angle Light around
the bezel and twist it in either a clockwise or counter-clockwise direction.
(Image 15)
y This action will cause the side of the light to disengage from the charger
and slip past the Spring-loaded Gripper. (Image 16)
y While maintaining an approximate 45 degree angle to the light, pull the
light straight away from the charger. (Image 17)
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
Image 13 Image 14
Image 16 Image 17
y The light has now been safely removed from the charger and is ready to
use.
CHARGING THE ANGLE LIGHT
WARNING: Use only the supplied Charger, Lithium-ion Rechargeable
Battery Pack and AC or DC Power Supply for charging. Do not attempt
to charge this light with non-rechargeable or rechargeable AA batteries
installed.
y The time required to charge the Angle Light is conditional on the remaining
charge left in the Lithium-ion Rechargeable Battery Pack at the time of
charging. The maximum charge time required is approximately 6 hours.
y Fully charge the Lithium-ion Rechargeable Battery Pack before the first
use, or if the Lithium-ion Rechargeable Battery Pack has been unused for
several months.
y Install the Angle Light into the charger using the exact method described
in this Instruction Manual above ("PLACING THE ANGLE LIGHT INTO THE
CHARGER"). WARNING: Failure to do so could damage the charger
and/or the light.
y When the Angle Light is properly seated in the charger, the LED Charge
Indicator light will turn solid RED indicating that the Lithium-ion Rechargeable
Battery Pack is charging (Image 14). The Lithium-ion Rechargeable Battery
Pack is fully charged when the LED Charge Indicator light turns GREEN.
y The Lithium-ion Rechargeable Battery Pack does not have any Recharge
Memory Effect, therefore placing the Angle Light in the charger prior to full
depletion of the battery does not adversely affect the battery life. The Angle
Light can be kept in the charger indefinitely without any negative impact on
the battery or the battery life.

OPERATION

THE XPR-5572RM HAS EIGHT SEPARATE LIGHTING MODES:
Image 18
Flashlight Modes
To activate the Flashlight, press and release the Flashlight Switch (Image
18). The default mode will be High-brightness. To select the brightness level
for the Flashlight, press and hold the Flashlight Switch. The flashlight will
cycle from high to medium to Survival and then back up again at a rate of
approximately one mode per second. The light will continue to cycle up and
down through the various modes as long as the switch is held down. When
the desired brightness level is reached, simply release the Flashlight Switch,
and the light will remain in that brightness mode. To turn the Flashlight off,
press and release the Flashlight Switch one more time.
Strobe
To activate the Strobe, double click the Flashlight Switch (Image 18). To
turn the Strobe off, press and release the Flashlight Switch one more time.
Floodlight Modes
To activate the Floodlight, press and release the Floodlight Switch (Image
18). The default mode will be High-brightness. To select the brightness level
for the Floodlight, press and hold the Floodlight Switch. The floodlight will
cycle from high to medium to Survival and then back up again at a rate of
approximately one mode per second. The light will continue to cycle up and
down through the various modes as long as the switch is held down. When
the desired brightness level is reached, simply release the Floodlight Switch,
and the light will remain in that brightness mode. To turn the Floodlight off,
press and release the Floodlight Switch one more time.
Dual-Light Mode
Dual-Light mode allows the user to turn on both the Flashlight and the
Floodlight at the same time. Dual-Light mode can be activated by simply
pressing the Flashlight Switch and then the Floodlight Switch or the Floodlight
Switch and then the Flashlight Switch (Image 18). If the Angle Light already
has the Flashlight or the Floodlight on (regardless of what brightness mode
INS-XPR-5572RM-17
High-brightness Flashlight
y
Medium-brightness Flashlight
y
Survival-mode Flashlight
y
Flashlight Strobe
y
High-brightness Floodlight
y
Medium-brightness Floodlight
y
Survival-mode Floodlight
y
Dual-Light (both the Flashlight and Floodlight
y
on at the same time)
9-19-2017