Remove The Insulating Strip From The Remote Control; Battery Replacement For The Remote Control - Sandstorm S20iBTW12E Instruction Manual

Remove the Insulating Strip from the Remote Control

Remove the insulating mylar strip from the battery if the
battery is being used for the first time. It is located at the
bottom rear side of the remote control.
GB

Battery Replacement for the Remote Control

The remote control requires a CR2025, 3V Lithium battery.
1. Use the tip of your thumb and forefinger
nails together. With your thumb, pull
the locking mechanism towards your
forefinger. Use your forefinger nail to slide
out the battery compartment.
2. Pull out the battery holder and remove
the old battery.
3. Replace it with a new battery (with the +
polarity face down).
4. Slide the battery holder back into the
remote control. Ensure it clicks into place.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could result in fire, personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the battery
compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with
the local regulations.
• Small button cell batteries such as the one used in the remote control are easily
swallowed by young children, this is dangerous. Keep loose button cells away from
young children and make sure the battery holder tray is secure in the remote control.
Seek medical advice if you believe a cell has been swallowed.
12