At&t’s lte/hspa+ 4g lte compatibility, snapdragon processor with 1.5ghz dual cpus, 4.5" true hd ips display, 1.3 mp front-facing camera, 8.0 mp hd rear-facing camera and camcorder with led flash, hotspot with wi-fi direct and wi-fi share (116 pages)
At&t’s lte/hspa+ 4g lte compatibility, snapdragon processor with 1.5ghz dual cpus, 4.5" true hd ips display, 1.3 mp front-facing camera, 8.0 mp hd rear-facing camera and camcorder with led flash, hotspot with wi-fi direct and wi-fi share (104 pages)
Page 1
• Heat Gun / Blow Dryer This guide will show you how to disassemble the LG Nitro HD mobile phone, assisting in making the repair of the device both simple and inexpensive. Following the steps we have provided will help you quickly, and safely, replace not only a broken display, but also any other internal components that may have become damaged.
LG Nitro HD–Disassemble Guide Step 1 – Battery • Begin to disassemble the LG Nitro HD by removing the back cover. • Insert the plastic opening tool in the notch that is in the back cover of the phone. Pry at this point to release the clips holding the cover down to the phone.
Step 6 – Rear-Facing Camera • Pry up the rear-facing camera using the spudger and remove it from the LG Nitro HD. http://www.fixez.com/ Page 3 of 9...
Page 4
LG Nitro HD–Disassemble Guide Step 7 – Headphone Jack • The headphone jack is easily removed with the spudger and a little prying. Step 8 • Use the spudger to pry up the two connections on the motherboard for the front-facing camera and earpiece speaker.
Page 5
Step 11 • With all the connections released, you can now lift the motherboard away from the LG Nitro HD. Step 12 – Touch Screen Locate and remove the four small Phillips screws •...
Page 6
Step 14 With the Phillips screws removed and the ribbon • cables released, the touch screen is free to separate from the frame of the LG Nitro HD. Step 15 Use the heat gun/blow drier to soften the adhesive •...
Step 17 – Earpiece Speaker • The earpiece speaker is secured down with adhesive. Use the spudger to release and remove the earpiece speaker from the Nitro HD. Step 18 – Front-Facing Camera Push the front-facing camera through from the back •...
Page 8
The home button assembly is held down with a small amount of adhesive. Using the spudger, carefully peel up the home button assembly and remove it from the LG Nitro HD. Step 21 - LCD In preparation for removing the LCD, peel back •...
LG Nitro HD–Disassemble Guide Step 22 Use the spudger to peel the LCD ribbon cable from • its securing adhesive. Still utilizing the spudger, separate the LCD from the phone’s frame. Final Layout To reassemble your device, follow these instructions in reverse order.