Inkbird Temperature Controller Setup - Store It Cold CoolBot Setup
How to set up your cooler for the winter season
Hide thumbs
Also See for CoolBot:
- Manual (38 pages) ,
- Instruction manual and troubleshooting manual (20 pages) ,
- Instruction manual (16 pages)
Table of Contents
Advertisement
If your INKBIRD Temperature display (the number at the top – labeled PV) is
•
different from the one displaying on the CoolBot, adjust the Temperature
Calibration (CA) of the INKBIRD sensor by following the instructions on the
INKBIRD manual. The objective is to have both sensors reading almost the same
temperature (within 1°F is ok).
Adjust the Setting Value (SV) temperature on your INKBIRD to 34°F/1.1°C
•
following the instructions in the INKBIRD manual.
STORE IT COLD, LLC
3879 TENNYSON ST.
DENVER, CO 80212
Advertisement
Table of Contents
Need help?
Do you have a question about the CoolBot and is the answer not in the manual?
Questions and answers