Advertisement
4
Routing and Connecting
the Power Harness
Parts needed for this procedure:
1
Power harness
6
Cable tie
Routing the Ring Terminals
to the Battery and Electrical
Compartment
Important:
Route the power harness away from
exhaust components and moving parts.
1.
Route the 2 ring terminals of the power harness
under the area where the battery compartment
is located
(Figure 4
Machines without a Cab
1. Power harness
or
Figure
5).
Figure 4
2. Ring terminals
1. Power harness
2.
Route the ring terminal of the power harness
labeled B+ through the opening at the back,
outboard corner battery compartment
1. Power harness
2. Fuse (10 A) and fuse
holder
g252785
3.
Route the ring terminal of the power harness
labeled
GROUND BLOCK
compartment and through the opening near
the forward inboard corner of the electrical
compartment
Assembling the Ring Terminals
to the Battery Cable and Ground
Block
1.
Remove the battery-clamp nut from the battery
clamp bolt of the positive battery cable
14).
3
Figure 5
Machines with a Cab
2. Ring terminals
Figure 6
3. Ring terminal (B+)
4. Ring terminal—power
harness (
GROUND BLOCK
under the battery
(Figure
6).
g252784
(Figure
6).
g252791
)
(Figure
Advertisement
