Bus Operating Mode; Bus-2 User Address; Led Indication - Honeywell IB2 Mounting And Connection Instructions

Mounting and Connection Instructions IB2 16 I/O Expander
6.3

Bus operating mode

ON
1 2 3 4 5 6
Bus operating mode
6.4

BUS-2 user address

BUS-2 address
ON
1 2 3 4 5 6
(Only when using as BUS-2 user)
Set the BUS-2 address using DIP switch S1 to S6.
The illustration shows the position and valence of
the switches.
In the event of several users,
assigned its own address.
Permissible address range:
7.

LED indication

ON
1 2 3 4 5 6 7 8
LED indication
LED 1
The DIP switch S8 is used to define the indication mode of the LEDs.
(The DIP switch S8 is accepted when in operation.)
LEDs in normal mode
LED flashes red
LED lights up red
LED flashes yellow
LED flashes green rapidly (0.5 sec.) Module is not polled
LED flashes green slowly (2 sec.)
LEDs in status mode
LED red lights up
LED flashes yellow
LED flashes green
IB2 operating mode
BUS-2 operating mode
7 8
7 8
each user must be
1 to 63.
2 3
(S8 in position OFF )
Device has identified an error
UB is < 9.2 V, OK again when UB > 9.5V
Tamper
Module is polled
(S8 in position ON )
Status mode is activated
At least one input is not completed or at least one input is
activated as an output (clearing doesn't count).
At least one output is active.
: S7 in position ON
(no address required)
S7
: in position OFF
ON ON
1 2 3 4 5 6
OFF
1 2 4 8 16
Valence
Address 1 Address 2
ON ON
1 2 3 4 5 6 1 2 3 4 5 6
Address 4 Address 5
ON ON
1 2 3 4 5 6 1 2 3 4 5 6
Address 61 Address 62
ON ON
1 2 3 4 5 6 1 2 3 4 5 6
23
All switche s set
at "OFF" position
32
Address 3
ON
1 2 3 4 5 6
Address 6
ON
1 2 3 4 5 6
Address 63
ON
1 2 3 4 5 6