Etlin-Daniels RTP42 Series Installation

INSTALLATION FOR RTP42 SERIES

SAVE THESE INSTRUCTIONS - READ ALL INSTRUCTIONS CAREFULLY

WARNING

PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION.
• Luminaire must be installed, checked and repaired by an authorized electrician.
• This product must be installed in accordance with the applicable installation code by a person familiar
with the construction and operation of the product and the hazards involved.
• For proper operation, make sure to connect the luminaire to the proper voltage and install it according
to these instructions.
• For safety purposes, cut off the power and allow the luminaire to cool before installing or removing it.
• Don't install the panel light to an unstable ceiling or near combustible materials.
• Cut off the power if there are any unexpected occurrences.
• Do not alter or modify the luminaire or change any of the components.
• Do not use the luminaire under conditions of direct sunlight, humidity, fog, rain, corrosive gas, dust, or liquid.
INPUT
MODEL FREQUENCY
VOLTAGE
RTP4214
100 - 277Vac
RTP4222 50-60Hz
120 - 347Vac
RTP4224

WIRE CONNECTION

0 - 10VDC DIMMABLE

UTILIZATION OF EARTHQUAKE CLIPS

1. Pull earthquake clip away from panel until facing perpendicular to
the panel surface.
POWER
INSTALLATION METHOD
CONSUMPTION
40W
Recessed in plaster or
grid ceilings. Utilization of
40W
Earthquake Clips
Surface-Mounted
50W
2. Bend earthquake clip 90°.
Head Office - 1850 Wilson Ave. · Toronto, ON · M9M 1A1 · Tel: 416.741.7336 · Fax: 416.741.9104
Toll free: in Canada. 1.800.661.9610 · in USA. 1.888.762.5384 (SOCKETS4U)
www.etlin-daniels.com· For sales/service questions - sales@etlin.com

RECESSED IN PLASTER OR GRID CEILINGS

1. For installation in plaster ceilings, cut an opening
of the appropriate size, and then connect the panel
light to an incoming power line.
3. Pass the panel through the ceiling surface.
3. Install panel light on grid supports.
2. Rotate the panel light by 45 degrees.
4. Lay in the panel light on the ceiling surface or grid.