Advertisement
Available languages
Available languages
QUICK START OF ARZ SOLAR ROLLER SHUTTER
ZWP S8 remote control is supplied in one packaging with the roller shutter
The roller shutter is factory programmed on channel No. 1 !!!
Install the roller
ARZ Solar
shutter in accordance
with installation
instructions of NC93E
HA 283
HA 283
HA 288
HA 237
HA 288
HA 233
HA 241
HA 242
HA 241
HA 242
Information concerning programming, change of parameters, changes in configuration settings, calling
individual functions is contained in the Programming and Usage Instructions (code NC97C).
The roller shutter is equipped with the manual operating button positioned in its upper part. It enables control
of the roller shutter in case of losing the remote control or wearing off its batteries. If after mounting the roller shutter
cannot be launched via the remote control, check operation from the manual operating button.
If the roller shutter works from the manual operating button, and yet it cannot be launched via remote control,
make RESET and go to PROGRAMMING !!!
RESET
RESET OF THE ROLLER SHUTTER
x2
1
I N / E X
x1
2
RESET OF THE REMOTE CONTROL
3
x2
I N / E X
4
PROGRAMMING
1
1
2
I N / E X
x1
4
3
1
x1
4
CONTROL
x1
Calling other procedures such as DELETE, EXCLUDE, LEARN MODE, DEVICE CONNECTION is described in programming instructions attached to the ARZ Solar roller shutter.
Information on how to perform programming of Z-Wave devices with the use of remote controllers of other manufacturers is to be found in the manuals of these devices.
NC860 22.11.2013
Make sure that
the main switch
of the roller shutter
is set to channel No.1
SIGNALLING
2 3
2 3
1
4
2 3
x1
1
SIGNALLING
x1
1
2 3
1
x1
2 3
2 3 4
1
1
1
Remove foil strip
to unlock the batteries
in the remote control.
1
4
1. Screw out the screw on the back of the remote control.
2. Pull out up back part of the remote control to access IN/EX programming button.
2 3
2 3 4
1
4
1
Button for folding
the roller shutter
Button for stopping
the roller shutter in
desired position
Button for unfolding
the roller shutter
First group of button of movement
Check the operation
of the roller shutter
unfolding.
x1
x1
ADDITIONAL INFORMATION
2
I N / E X
Choose one of four available channels, e.g. No.1
1 – channel one – control of the roller shutter No. 1 and No. 2
2 – channel two – control of the roller shutter No. 3 and No. 4
3 – channel three – control of the roller shutter No. 5 and No. 6
4 – channel four – control of the roller shutter No.7 and No. 8
1 2 3 4 – common channel – control of two groups with
4 roller shutters in each
3
2
2 3 4
1
2 3 4
1
1 1 1
Button for channel selection
Button for stopping
the roller shutter in
desired position
Button for unfolding
the roller shutter
Second group of button of movement
GB
Check the operation
of the roller shutter
folding.
I N / E X
4
Button for folding
the roller shutter
Advertisement
